![]() G90 G0 X0.65 Z0.2 (Absolute Dist Mode, Rapid move to X and Z - Safe X and Z) G95 (Units/Revolution activated, ERROR IF NEW FEED RATE IS NOT SPECIFIED) G97 S500 M3 (Spindle RPM Mode, Speed = 5500, Start spindle clockwise) (G30 Tormach uses G30 rather than G53 - same unless G30.1 used to set X&Z) (also Post Options for X only, Z only, etc) (Rapid to machine Z=0 : Post Option or G28) (Rapid to machine X=0 : Post Option or G28) ![]() ![]() The Post(s) aren't too long and came out like this: I ran this with two posts, one for LinuxCNC Turn and one for Tormach Slant Bed. I built a 1/4" rod in Fusion and asked for a 1/4-20 threading operation. I'm leaning Fusion and started poking at LinuxCNC posts for the lathe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |